Are you looking for an elegant wall lamp that is not too flashy? Then the "Stanley" wall lamp from Luxform is the perfect choice! Since there is a transparent cylinder on the underside of the lamp, the lamp emits an amazing light of up to 140 lumens with the help of the 48 warm white LEDs! Think of the fence and / or wall to highlight plants. Of course, the lamp can also be used in a practical way by placing it next to the front or back door, and it can also clearly illuminate stairs. It is a single 12V lamp. Therefore, a connection cable and transformer must be purchased separately so that everything to connect the lamp is available. The Stanley wall lamp is made of aluminum and is therefore low-maintenance.

Info 12V lighting:

Luxform 12 volt lights are suited for every possible use of light in your garden. The lights are totally safe for animals and playing children. The cables are quickly and easily connected with the unique “Easy Twist” system and can be used just underneath the surface without the need of gullies or additional tools.

1. Select the lights you want to use in your garden. Will you chose lanterns for extra atmosphere; spotlights to highlight special plants or features; built-in lights for in your decking, paving or perhaps something in or around the pond?

2. Count up the wattages of all lights chosen. Now you can decide on which transformer to use (available in 20W, 60W and 105W. By counting the wattages of the individual lights, you can determine the capacity of the transformer you require. You may need to allow for extra lights at a later stage. Note: the capacity (wattage) of the transformer always needs to be greater than the total wattage of the lights in your system.

3. Measure the distance from the transformer to the furthest light to be installed. This length of cable is needed to install all the lights. The Luxform main cable has a transformer plug attached and has a length of 15 metre. A 10 metre extension cable can be added. 

= Easy Twist Connect After choosing your lights, the only thing there is left is to place and connect them. This is simple to do due to the Luxform Easy Twist and connect system. Place the main cable and the cable of the lamp inside the connector. Place the cap on and twist them together to make the connection. The connector is water-resistant